kenmore elite washing machine

[jpfroth]

my washing machine is leaving my clothes wet after spin cycle. it is a kenmore model # 11022932102, i have run machine without clothes through a rinse and spin cycle. water drains and tub spins.

[jeff1]

Hi,


110.22932102

A direct drive washer.


my washing machine is leaving my clothes wet after spin cycle

A poor or slow spin is more often a bad clutch or ground out drive block. If the drive block checks ok ( can be checked visually ) the clutch is normally replaced.
LINK> http://www.applianceaid.com/direct-drive-washer-not-spinning.php

If needed:

236 Clutch complete, large capacity automatic washer (http://www.repairclinic.com/referral.asp?R=153&N=831493)

237 Drive block for inner tub (http://www.repairclinic.com/referral.asp?R=153&N=2858)

jeff.

[jpfroth]

i just replaced thge clutch on the washing machine. But now I'm having an issue with the drum starting to wobble when it reaches high speed spin. could this be caused from a worn drive block? (i spoke to someone and they mentioned this as a sign of a worn drive block) or do you think it could be caused by something else? when i reassembled everything it all went back into place very easily. So I'm stumped as to the cause of this wobble now. once again any help would be greatly appreciated.

[jeff1]

But now I'm having an issue with the drum starting to wobble when it reaches high speed spin.

Just the wash basket or the whole drum/basket assembly?


when i reassembled everything it all went back into place very easily.

Layed the washer down at all?
http://www.applianceaid.com/washer-suspension-help.php

jeff.

[jpfroth]

Just the wash basket or the whole drum/basket assembly?



Layed the washer down at all?
http://www.applianceaid.com/washer-suspension-help.php

jeff.

yes the whole basket & drum assembly are moving as if there were a load of laundry in it and of balance. yes I layed it down in order to change the clutch.

[jpfroth]

Jeff I checked out the applianceaid.com site and that was my problem the suspension plate had shifted. Thank you for all of your help, I will definitely be using this site in the future for all my appliance trouble shooting.

[jeff1]

Thankx for the update :)

jeff.