Drain Pump Power Connector

[Dinglestains]

Hi,

I have a bad drain pump on my washing machine. When I was checking the voltage to the drain pump, I accidentally touched the two multimeter probes together causing a flash. This damaged the power connector that goes to the drain pump. Does anyone have a clue how I can get the metal leads out or where I can find a replacement connector? It may be easier if I just cut the wire and put on a new connector. I have attached a few images to the post.

Here's some information about my washer if it helps at all:
White-Westinghouse
WWS833ES0
Manufactured in 2006

The part number for the drain pump is 137108100 if this is any help.

Here are the images:

241

242

243

I appreciate any help.

Thanks in advance.

[jeff1]

Hi,

Best bet is to just cut the wire plug and add a couple of insulated wire terminals and plug the individual wires to the drain pump...

244 Insulated spade terminal (http://www.repairclinic.com/referral.asp?R=153&N=470739)

jeff.

[Dinglestains]

Hi,

Best bet is to just cut the wire plug and add a couple of insulated wire terminals and plug the individual wires to the drain pump...

244 Insulated spade terminal (http://www.repairclinic.com/referral.asp?R=153&N=470739)

jeff.

Thanks for the advice. I ended up doing this and it worked out nice. I appreciate the help.

[jeff1]

Thankx for the update :)

jeff.