error code E2 F3 on maytag YMHWE251YL00 front load washer

[roughrider]

hello, my wife called me down to the basement and showed me the error codes of E2 F3 on front load washer, i did some investigating and found that it says water temperature sensor. i was wondering if this is the problem and if someone could point me to a wiring diagram and the location of the sensor. i have traced the wire to a grey plug going to the computer on the upper set of plugs. if this is the correct plug then there is no resistance reading.

if this sensor is at the base of the washer on the right side front then there is a ohm reading of 12.8

[jeff1]

Hi,

Going to have to check inside the machine for the tech sheet....I tried Maytag & Whirlpool and came up empty for both.....just keeps telling me "model# not found".
Model# is good for parts breakdowns, but nothing is coming up for the fault codes or tech sheet.

#23 comes up as a heat sensor...

453
454 Heater sensor Manufacturer Number W10467289 (http://www.repairclinic.com/referral.asp?R=153&N=2629420)


http://www.youtube.com/watch?feature=player_detailpage&v=_kH4aAhi8K4

Sorry couldn't find more.

jeff.

[roughrider]

hi, im pretty sure that that is the problem jeff, i went down after about an hour and it was all working again. i will pull the connector off and recheck the resistance this am, if there is resistance i will order a sensor as yesterday there was no reading. ill keep you posted and thanks very much for the help jeff.

[jeff1]

ill keep you posted

Great :)

jeff.