Washer fixed! 69 bucks! Thanks for your hand up Jeff. Couldn't let it beat me. Kudos to you, this blog and Repair Clinic.
Justus
Type: Posts; User: Justus
Washer fixed! 69 bucks! Thanks for your hand up Jeff. Couldn't let it beat me. Kudos to you, this blog and Repair Clinic.
Justus
Will do. Appreciate your help Jeff. Will order part and report back after install and testing.
Justus
Jeff, hooked 110 from direct outlet to wax motor via a chopped extension cord with 2 alligator clips. The wax motor piston started slowly to extend, but after 2 1/2 minutes still barely did not make...
Ok Jeff, what now. The board is bad? Could it be anything else?
Ohm reading
513
Ok, I touch the 2 connectors on the wax motor and got a reading of 1.586 ohms with the meter set at 2k ohms
My door latch
512
Just a little confused on which contacts to check with ohm meter?
Jeff, just a question. I have yet to receive a display on the led of an error when running a load. Even if it doesn't display an error, is it still recorded in memory. Reason I say that is because 6...
I have not seen any error codes since it stopped spinning. It just bypasses spin and tosses. There's been no spin during wash, just agitate
Error code E47
I just tried the diagnostic test holding the pause/cancel and options buttons. Went 8 clicks clockwise and washer started to spin. I would have to assume the problem is the motor control board...
Jeff. I ordered the part you suggested. Took the top off washer and replaced it. Still doing same thing. I took the part back out and pulled the small hose off it and blew air thru it. I then took a...
417.44092500 got this off inside of door, other was from manual.
I have a kenmore 44092 front load. It goes thru the full cycle until the final spin. At that point it does the final toss and buzzes, no error code. The cloths are sopping wet. There is no water left...