Search:

Well, it works. And I'm embarrassed to say how I fixed it. You know how i said the hose wasn't clogged? It wasn't. But the knock out plug from the garbage disposal was never removed. :rolleyes:
...

House drain is fine. Hose is correct. How do you prime the pump? There is water in the cabinet. Can I put water down the ejection hose so water is on that side of the hose or since the air gap is in...

Right on. :)

I volt tested the drain motor when it called for drain after the rinse cycle. It read 120v and did not eject the water. The motor made an audible hum. No drain.

I therefore...

Holy cow. I have no idea how I'm going to get to the pump with it hooked up. There is zero room or clearance. Ok, thanks. I'll figure something out.

Stupid question - You mean just run a ACV test on the 120v wire coming out of the wall, right?

I pulled the dishwasher out and ran a continuity test on the pump. I believe it tested fine. I got a tone indicating continuity when the pump was disconnected from the electrical terminals. I forgot...

Is there a trick to running a meter to this pump? I can see it by removing the bottom access panel but I can hardly get to it. It looks like a recycled water tube off the sump is in the way. It's...

Hi,

My grandmother has a Frigidaire Gallery Series mdl# GLDB656JS0 dishwasher that's not draining. I checked the drain line and it's not clogged. I cleaned the screen, it was okay.Removed the top...

It turns out the front pin that keeps the switch in place for when the rocker arm strikes it was broken. So it had fallen out of place and wasn't being pressed. I fixed it with a bracket I made....

Sorry, PU & WH?

Thanks for the help.

No hum when calling for water. I'm not sure how to test for voltage on fill valve. I left the fridge plugged in and slid the connector back a bit to expose the contacts. I set the meter to 250 AC. It...

Hi.

I have a Whirlpool fridge model ED25PQXFW00 and the water dispenser does not dispense water. Ice maker works fine. I had a new inlet solenoid lying about and swapped it out but it still does...

Drum bearing and the glides were shot.

Heating element tested okay.

Apparently the timer doesn't work anymore, I learned yesterday. Any of the fancy dryer options (perm. press, cotton, etc)...

Thanks a bunch. I'll check it out.

My sister has a GE Dryer model DWSR483EA0WW, about 12 years old.

It has a couple of strange problems.

#1 The low heat setting produces heat so hot that the clothes are hard to handle after a...