Page 2 of 2 FirstFirst 12
Results 11 to 16 of 16

Thread: Kenmore Top Load Washer Not Spinning the Clothes Dry

  1. #11
    Join Date
    Oct 2014
    Posts
    7

    Default

    Quote Originally Posted by jeff1 View Post

    Diagnostics complete. All indicators point to faulty Drive System–Shifter.

    Will order the $45 part (w10006355) soon and report back. Thanks for the help, I really appreciate it.
    Last edited by SixFoot; 10-23-2014 at 04:51 PM.

  2. #12
    Join Date
    Feb 2012
    Location
    Canada
    Posts
    1,278

    Default

    Glad to see you are getting somewhere...

    Name:  Shift-Actuator-W10006355--01390084.jpg
Views: 95
Size:  3.3 KB LINK> Mode shift actuator



    jeff.
    http://www.applianceaid.com/
    Appliance Repair Aid

  3. #13
    Join Date
    Oct 2014
    Posts
    7

    Default

    Sad to say I got the shift actuator in and it did not fix the problem. Thoughts?

  4. #14
    Join Date
    Feb 2012
    Location
    Canada
    Posts
    1,278

    Default

    What happens instead of spinning? Main motor is running, hummmming? Water drains out ok?
    What was the fault code(s) that come up?
    Did you have to run the calibration mode?

    jeff.
    http://www.applianceaid.com/
    Appliance Repair Aid

  5. #15
    Join Date
    Oct 2014
    Posts
    7

    Default

    From what I've been able to determine, I have two fault codes.

    These are the possibilities when only the Sensing light is illuminated under the check fault option:

    F0E2 – OVER SUDS CONDITION DETECTED
    F0E4 – HIGH WATER TEMPERATURE – RINSE CYCLE
    F0E5 – OFF BALANCE LOAD DETECTED

    ^I have ruled all of these out. Water lines are correct, suspension is solid, washer is lever etc..


    These are the possibilities when all but the wash light are illuminated:

    F7E5 – SHIFTER FAULT
    F7E6 – MOTOR FAULT
    F7E7 – MOTOR UNABLE TO REACH TARGET RPM

    ^I have performed all the mechanical and electrical tests. Continuity is good, basket moves freely etc..


    After installing the new actuator, I cleared the fault codes, ran calibration, then the auto self-test. Afterwards, I set it to Drain/Spin mode to see if it worked. No such luck... Basket still starts to spin, then stops spinning. Water drains just fine.

    Something new happened with it yesterday, though. I left the laundry room and came back an hour later to see it full of water and agitating like it was on a normal wash cycle (it was still on Drain/Spin only). At this point, I'm casting blame on the Main Control Board. I still hope the resolution isn't to replace the most expensive part on the machine ($130), but its all I can think of at this point. Greatly vexing, as the life of use this machine has seen was less than a year of in-home use followed by less than a year in dry storage.

  6. #16
    Join Date
    Feb 2012
    Location
    Canada
    Posts
    1,278

    Default

    I wish I knew more about these, just not many yet in my area....sorry.

    jeff.
    http://www.applianceaid.com/
    Appliance Repair Aid

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •