Maytag Neptune TopLoader washing machine water extracting issues

[kwall139]

I have a Maytag Neptune Top loader washing machine. It seems that when the setting for spinning (water extracting) the tube makes a noise and the clothes are still wet when spin cycle is complete. I know the controll panel is basically a mother board and I have changed that 2 years ago. Since then the water that flows into the softener spot doesnt work along with the bleach dispenser. Any sugestions would be greatly appreciated.


Kwall139

[jeff1]

Hi,

Maytag Neptune TopLoader washing machine

Model#?
http://www.applianceaid.com/model-number.php Some model# helps.

It seems that when the setting for spinning (water extracting) the tube makes a noise and the clothes are still wet when spin cycle is complete.

The ?wash tub? makes a noise but doesn't spin? Is all the water gone at the end of the cycle?

I have changed that 2 years ago. Since then the water that flows into the softener spot doesnt work along with the bleach dispenser.

Started right after your repair?...if yes, no one considered you may have a defective part or maybe a wrong part?

jeff.

[kwall139]

The was tub extracting issue and dragging noise just start within the last week. And yes the water seems to be gone from tub. The bleace and softner
issue about a year ago.

[jeff1]

Did you find the model#??
http://www.applianceaid.com/model-number.php Some model# helps.

jeff.

[kwall139]

Sorry about that, Model # is FAV68UOAWW - Ser # is 10433518EE..

Thanks,

Korey

[jeff1]

FAV68UOAWW

I got FAV6800AWW to work for me.

It seems that when the setting for spinning (water extracting) the tube makes a noise and the clothes are still wet when spin cycle is complete

Try the quick spin test...

Quick Spin Test
While in Service Mode, press the
Hand Wash
key to start a
Quick Spin
Test.
Quick Spin test steps are as follows:
1) Lock the lid.
2) Spin to index speed 90 rpm and hold for 60 seconds. Pump drains machine.
3) Spin to index speed 150 rpm and hold for 6seconds
4) Spin to index speed 350 rpm and hold for 6 seconds.
5) Spin to index speed 550 rpm and hold for 6 seconds.
6) Spin to index speed 700 rpm and hold for 6 seconds.
7) Spin to index speed 850 rpm and hold for 6 seconds.
Pump out.
8)Coast down to 0 rpm chimes 3 times.

Place a piece of tape on each tumbler ( access from each other ) before starting the spin test. After the spin test, see if the tape are still lined up with each other or are they off-set now.

Service manual linked below...
http://www.applianceaid.com/pdf/_docs_16022808.pdf

jeff.