kitchenaid icemaker ksra221

[joefriday]

hello, i have a kitchen side by side kitchen refr. # ksra221. The icemaker isnt working. its the type that sits sideway, no arm.
i remove it and tested the t and h with a jumper. The motor went around and i could hear the heater heating. i tested the v and L and water came out.
The light above the beam is blinking two blinks. If i block the beam when the motor is moving, it stops.
Now what?
Thanks for your time,
Joe

[jeff1]

Hi,

The light above the beam is blinking two blinks

That would seem to be bad, a copy:

Step#1: Open the freezer and view the status led

(STATUS LED)

2 BLINKS FOLLOWED BY 1 SEC. DELAY (REPEATED)

POSSIBLE CAUSES: The flapper door on the emitter is blocking the beam or the optics are faulty.

Step#2: Press the emitter flapper to unblock the optics beam

(STATUS LED)

2 BLINKS FOLLOWED BY 1 SEC. DELAY (REPEATED)

POSSIBLE CAUSES: The optics are faulty. Replace the emitter and receiver boards.

If the LED is on steady: The optics are working properly.

ksra221

Too short, appears to be part of a full model# and that 1 may be an I (eye).
http://www.applianceaid.com/model.html

Power control board kit, emitter and receiver icemaker control Manufacturer Number 4389102

May learn some more once we have a full model#.

jeff.